Select Page
 

Single-phase low-level Wacker Neuson Submersible Pumps

These high performance single-phase submersible pumps are ideal for job sites needing fast, dependable, low level water pumping. Pump can start in less than 1/4-inch of water when it is primed through the discharge port. No matter how large or small the job. Wacker Neuson submersible pumps offer the versatility and durability contractors need for light dewatering. Suitable for most 110V outlets, these pumps offer big pump features for small pump investment.

  • Pumps feature a top discharge for efficient motor cooling and continuous operation, even when pumping at low water levels.
  • Miniature thermal motor protector prevents overheating and dry run conditions.
  • Multi-directional discharge coupling for vertical and horizontal hose run without kinking.
  • PSG2 500 is ideally suited for low pump applications with minimal solids present. It can pump a reasonable flow sitting on the surface.
  • PSR1 500 is ideal for dewatering of flat concrete, like basement and factory floors. For use where a sump pump cannot be installed and water must be almost completely removed.
single-phase low level submersible pump

Single-phase low-level Wacker Neuson Submersible Pumps

PDF Icon
 

Single-phase Wacker Neuson Submersible Pumps

No matter how large or small the job, Wacker Neuson’s single-phase submersible pumps offer the versatility and durability contractors need for light dewatering on the job site. This comprehensive family of pumps offers big pump features for a small pump investment.

  • These high performance single-phase submersible pumps are capable of handling solids up to .4 inches, ideal for job sites needing fast dependable dewatering.
  • Lightweight, compact design with heavy-duty strain relief power cord offers a highly durable pump that is still easy to transport and install.
  • Built-in thermal protection prevents motor damage due to impeller blockage, reducing service repairs.
  • Silicon carbide-faced double mechanical seals run in an isolated oil-filled cavity, allowing for seal lubrications, cooling and overall motor protection.
  • PST models feature shaft-mounted agitators which suspend solids when pumping sand and debris. Built with ductile iron hosing for excellent wear life when pumping water with some entrapped solids.
Single-phase Submersible Pump

Single-phase Wacker Neuson Submersible Pumps

PDF Icon
 

Three-phase Wacker Neuson Submersible Pumps

No matter how large or small the job, Wacker Neuson’s three-phase submersible pumps offer the versatility and durability contractors needs for dewatering on the job sites. This comprehensive family of pumps offers big pumps features for a small pump investment. The heavy-duty line is capable of handling solids up to .08 inch (20 mm) and are ideal for job sites needing fast and dependable dewatering.

  • Slim line design with top discharge enables operation at low water levels for extended periods.
  • Built-in thermal protection prevents damage to motor windings in the event of dry run situations.
  • Durable high chrome impeller with ductile iron wear plate and extra lip seals reduces wear when pumping abrasive materials.
  • Silicon carbide double mechanical seals run in an isolated oil-filled cavity, allowing for seal lubrication, cooling and overall motor protection.
  • Heavy-duty power cord with stain relief and special water block insulation system increases durability and motor life.
three-phase submersible pump

Three-phase Wacker Neuson Submersible Pumps

PDF Icon